ELECTRICAL PARTS
ADJUSTABLE DC HI-PERFORMANCE CDI BOX
Most advanced brain box on the market for minis. Switches
your ignition system from AC to DC for a much stronger
and cleaner spark. Integrated computer chip advances
timing 25 degrees on take off for best bottom end then
retards back to zero as it reaches higher RPMs.
No rev limit installed.
Part Number:
DCCDI MSRP $140.95
HI-PERFORMANCE COIL
Produces a stronger spark for hi-performance motors.
Part Number: HIPERCOIL
MSRP $29.95
DELUXE DIGITAL METER
Measures engine rpm, max rpm, temp and run time.
Over-rev and over-heat warning lights.
Works on both 2-stroke and 4-stroke engines.
Easy to read back light LED display.
Dimensions: 83x46x21 mm
This gauge is the best we have and we have not seen it anywhere else. Comes with all
hardware needed to attach to the ATV and hook up all the wires. This is the ultimate gauge
that will read engine rpm at all times, engine maximum rpm, engine run time, engine
temperature and even has over-rev and over-heat warning lights.
Use this gauge to fine tune your clutch and gearing to achieve MAXIMUM RPM.
Why wait until your motor burns up to find out it was running too hot when you can install this
and its warning light will tell you when it is time to shut it down. Blue indiglow light is always on
until the warning red indiglow light goes off to warn you.
An absolute must have for all beginner and expert riders.
Can be used on any machine with a battery, or a small battery would need to be added.
For easier temperature reading installation also purchase:
Cylinder Head Temperature Sensor
Part Number:
BA002150 (back light LED) MSRP $104.95
CYLINDER HEAD TEMPERATURE SENSOR
Can be used with the Deluxe Digital Meter for reading cylinder head temperature at
the spark plug. Installs in seconds and plugs directly into the digital meter's wiring
harness.
Recommended for use with:
Deluxe Digital Meter
Part Number:
KI000R14 (50cc & 90cc) MSRP $21.95
STANDARD DIGITAL METER
Measures engine rpm, max rpm and run time.
Works on both 2-stroke and 4-stroke engines.
Great for setting up clutches and gearing with no battery
needed and no need to mount to ATV.
Quick and easy set up for checking out what the engine
is doing. Installs in just seconds.
Part Number:
BA002000 MSRP  $74.95
DIGITAL SPEEDOMETER
Digital speedometer mounts on handlebars and sensor
reads from rear rotor or sprocket. Some modifications
required.
Also has odometer and trip meter.
Fuel sensor can not be used on ATVs.
Part Number:
BB002B10 MSRP $124.95
ANALOG RPM GUAGE
Reads up to 14,000 rpm.
Carbon fiber face plate.
Includes all hardware to mount on handle bar clamp.
(50cc & 90cc)
Part Number:BA480B01
MSRP $99.95